And that previous error disappears, with the printer status now being this: Earlier while extracting the RPM, I saw this executable in the package contents, so I transfer it by scp to the /opt dir of my IPFire host. I finish everything up, and at the end, it says the printer has been successfully added.īut when I go to print a test page, it fails, and shows an error message saying File "/opt/OpenPrinting-SpliX/cups/lib/filter/rastertoqpdl" not available: No such file or directory. I then extract the contents of the RPM and found, unzipped it, and uploaded that at step 8 as instructed. The site only has RPMs or DEBs, so I grabbed the x86 64-bit 2.0.0 (RPM for LSB 3.2) package there is also a RPM for LSB 3.1 package (not sure if this makes a difference, though I don’t think so since both LSB 3.2 and 3.1 are well over a decade old at this point). Specifically, I download the needed driver from openprinting dot org.
Next I go through the steps provided in the official wiki to add and configure this single printer I have. (curiously it’s listed twice for whatever reason in this section, though I don’t think this is a problem nor that important)
0 kommentar(er)
